[New Updated Questions] High Pass Rate Cisco 100-105 Dumps Exam Details | CCENT ICND1 v3.0 100-105 Dumps PDF Study Guide On Yumpu
Trust the best-selling Pass4itsure 100-105 dumps series from Cisco Press to help you learn, prepare, and practice for exam success. They are built with the objective of providing assessment, review, and practice to help ensure you are fully prepared for your certification exam.
Exam Code: 100-105
Exam Name: Cisco Interconnecting Cisco Networking Devices Part 1 (ICND1 v3.0)
Updated: Jun 14, 2017
Q&As: 239
Exam Information: https://www.pass4itsure.com/100-105.html
The following are probably the most significant changes to the Pass4itsure 100-105 Dumps
- Configuring, verifying, and troubleshooting RIPv2 has been added to the ICND1 exam. Why RIP you might ask? Because RIP is a fairly basic and simple routing protocol to configure, Cisco felt it was a good choice to learn basic routing protocol concepts.
- The OSPF topics where moved to the Pass4itsure 100-105 dumps and curriculum.
- Device management and maintenance topics where moved from the ICND2 exam and curriculum into the ICND1 exam and curriculum.
- There is an increased 100-105 exam focus on troubleshooting throughout the exam topics. For example a troubleshooting topic has been added for port security, IPv6 addressing, and client- and router-based DHCP connectivity issues.
The Pass4itsure 100-105 dumps includes topics on the operation of IP data networks, LAN switching technologies, IPv6, IP routing technologies, IP services (DHCP, NAT, ACLs), network device security, and basic troubleshooting. The exam is closed book and no outside reference materials are allowed.
Share some Cisco Specialist 100-105 Dumps Exam Questions and Answers Below:
QUESTION 9
ROUTER# show ip route
192.168.12.0/24 is variably subnetted, 9 subnets, 3 masks
C 192.168.12.64 /28 is directly connected, Loopback1
C 192.168.12.32 /28 is directly connected, Ethernet0
C 192.168.12.48 /28 is directly connected, Loopback0
O 192.168.12.236 /30 [110/128] via 192.168.12.233, 00:35:36, Serial0
C 192.168.12.232 /30 is directly connected, Serial0 O 192.168.12.245 /30 [110/782] via 192.168.12.233,
00:35:36, Serial0
O 192.168.12.240 /30 [110/128] via 192.168.12.233, 00:35:36, Serial0
O 192.168.12.253 /30 [110/782] via 192.168.12.233, 00:35:37, Serial0
O 192.168.12.249 /30 [110/782] via 192.168.12.233, 00:35:37, Serial0
O 192.168.12.240/30 [110/128] via 192.168.12.233, 00:35:36, Serial 0
To what does the 128 refer to in the router output above?
A. OSPF cost
B. OSPF priority
C. OSPF hop count
D. OSPF ID number
E. OSPF administrative distance
Correct Answer: A
QUESTION 10
Refer to the exhibit.
A network associate has configured OSPF with the command:
City(config-router)# network 192.168.12.64 0.0.0.63 area 0
After completing the configuration, the associate discovers that not all the interfaces are participating in
OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this
configuration statement? (Choose three.)
A. FastEthernet0 /0
B. FastEthernet0 /1
C. Serial0/0
D. Serial0/1.102
E. Serial0/1.103
F. Serial0/1.104
100-105 Correct Answer: BCD
QUESTION 11
Refer to the exhibit.
Which two statements are correct? (Choose two.)
A. This is a default route.
B. Adding the subnet mask is optional for the ip route command.
C. This will allow any host on the 172.16.1.0 network to reach all known destinations beyond RouterA.
D. This command is incorrect, it needs to specify the interface, such as s0/0/0 rather than an IP address.
E. The same command needs to be entered on RouterA so that hosts on the 172.16.1.0 network can
reach network 10.0.0.0.
Correct Answer: AC
QUESTION 12
The ip helper-address command does what?
A. assigns an IP address to a host
B. resolves an IP address from a DNS server
C. relays a DHCP request across networks
D. resolves an IP address overlapping issue
100-105 dumps Correct Answer: C
QUESTION 13
Refer to the exhibit.
Host A can communicate with Host B but not with Hosts C or D. How can the network administrator solve
this problem?
A. Configure Hosts C and D with IP addresses in the 192.168.2.0 network.
B. Install a router and configure a route to route between VLANs 2 and 3.
C. Install a second switch and put Hosts C and D on that switch while Hosts A and B remain on the
original switch.
D. Enable the VLAN trunking protocol on the switch.
Correct Answer: B
QUESTION 14
Refer to the exhibit.
A network administrator is troubleshooting a connectivity problem on the serial interfaces. The output from
the show interfaces command on both routers shows that the serial interface is up, line protocol is down.
Given the partial output for the show running-config in the exhibit, what is the most likely cause of this
problem?
A. The serial cable is bad.
B. The MTU is incorrectly configured.
C. The Layer 2 framing is misconfigured.
D. The IP addresses are not in the same subnet.
100-105 pdf Correct Answer: C
QUESTION 15
Refer to the exhibit.
Serial 0/0 does not respond to a ping request from a host on the FastEthernet 0/0 LAN.
How can this problem be corrected?
A. Enable the Serial 0/0 interface.
B. Correct the IP address for Serial 0/0.
C. Correct the IP address for FastEthernet 0/0
D. Change the encapsulation type on Serial 0/0
E. Enable autoconfiguration on the Serial 0/0 interface
Correct Answer: A
QUESTION 16
Which of the following is true regarding the configuration of SwitchA?
A. only 5 simultaneous remote connections are possible
B. remote connections using ssh will require a username and password
C. only connections from the local network will be possible
D. console access to SwitchA requires a password
100-105 vce Correct Answer: B
QUESTION 17
Refer to the exhibit.
A problem with network connectivity has been observed. It is suspected that the cable connected to switch
port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected?
A. Host B would not be able to access the server in VLAN9 until the cable is reconnected.
B. Communication between VLAN3 and the other VLANs would be disabled.
C. The transfer of files from Host B to the server in VLAN9 would be significantly slower.
D. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network
function would resume.
Correct Answer: D
QUESTION 18
A receiving host has failed to receive all of the segments that it should acknowledge. What can the host do
to improve the reliability of this communication session?
A. decrease the window size
B. use a different source port for the session
C. decrease the sequence number
D. obtain a new IP address from the DHCP server
E. start a new session using UDP
Correct Answer: A
QUESTION 19
Refer to the exhibit
A user cannot reach any web sites on the Internet, but others in the department are not having a problem.
What is the most likely cause of the problem?
A. IP routing is not enabled.
B. The default gateway is not in the same subnet.
C. A DNS server address is not reachable by the PC.
D. A DHCP server address is not reachable by the PC.
E. NAT has not been configured on the router that connects to the Internet.
100-105 exam Correct Answer: C
As one of the hottest exams of Cisco certification, 100-105 exam is becoming more and more popular in today’s IT area. As a Optical certification, it is well known that passing the 100-105 dumps has become a global standard for many successful IT companies. Pass4itsure 100-105 dumps will provide you with questions and verified answers that reflect the actual exam.
Candidates can prepare for this exam by taking the “Interconnecting Cisco Networking Devices Part 1” (ICND1) v2.0 course. This https://www.pass4itsure.com/100-105.html 100-105 dumps tests a candidate’s knowledge and skills required to successfully install, operate, and troubleshoot a small branch office network.